Please use the diagrams below if you need help deciphering control orientation.
Using the drawings shown in the respective shock's section combined with the rear shock control diagram below, you should be able to figure out the proper direction for knob control. Ultimately, suspension performance that seems to be opposite of your intended adjustment will be ample notice that you went in the wrong direction—thus, it's safe to assume that the opposite direction will be the correct one.
A clockwise (also: IN) motion is one that proceeds 'like the clock's hands': from the top to the right, then down and then to the left, and back to the top. Conversely, counterclockwise (also: OUT) is one that proceeds from the top to the left, then down and then to the right, and back to the top.
Use this diagram to orient the controls in the fork drawings shown throughout FOXHelp. Knob control directions are relative to looking at the knob straight on. For controls on the bottom of the fork, this would mean that you would be on the ground and looking up at the fork controls.
Use this diagram to orient the controls in the rear shock drawings shown throughout FOXHelp. Knob control directions are relative to looking at the knob straight on. The Z axis may assist you in aligning certain drawings as some of them are not shown looking at the control straight on, but at an angle.
Bushing Technology & Inspection | Seals & Foam Rings | Control Direction | Oil Volumes | Structural Inspection | Dropout Thickness Inspection | Torque Values | Unit Conversion | Suspension Tuning Tips | Using the Pump | Important Safety Information | Service Intervals | Contact FOX Service | Warranty Information | FOXHelp Service Web Site
Copyright © 2010
FOX Factory Inc.